ATEN CS-1008 Bedienungsanleitung PDF herunterladen (Seite 15)

1. Introduction

No. Component Description

1 Handle Pull to slide the KVM module out; push to slide the module in

(see item 2 in this table).

2 Slide Release In order to slide the console out, you must first release it by

sliding these tabs to the inside. See page 13 for details on

sliding the console in and out.

3 LCD Display After sliding the KVM module out, flip up the cover to access

the LCD monitor.

4 LCD Controls The LCD On/Off switch is located here, as well as buttons to

control the position and picture settings of the LCD display.

See page 17 for details.

5 Port Switches Press a switch to bring the KVM focus to the computer

attached to its corresponding port. See page 19 for details.

6 Port LEDs Two Port LEDs are built into the Port Switches. The one on

the left is the On Line LED; the one on the right is the

Selected Port LED:

 An On Line LED lights ORANGE to indicate that the

computer attached to its corresponding port is up and

running.

 A Selected LED lights GREEN to indicate that the

computer attached to its corresponding port has the KVM

focus. The LED is steady under normal conditions, but

flashes when its port is accessed under Auto Scan Mode

(see F7: SCAN, page 33).

7 Keyboard Standard mouse touchpad

8 Touchpad Standard 105-key keyboard

9 Power LED Lights DARK GREEN to indicate that the unit is receiving

power.

10 Rack Mounting

Brackets

The rack mounting brackets located at each corner of the unit

secure the chassis to a system rack.

11 Lock LEDs The Num Lock, Caps Lock, Scroll Lock LEDs are located

here.

12 Reset Switch Located to the right of the Lock LEDs. Press this recessed

switch in with a small object to perform a system reset.

13 Firmware

Upgrade

Section

 Firmware Upgrade Port: The Firmware Upgrade Cable

that transfers the firmware upgrade data from the

administrator's computer to the CL1008 / CL1016 plugs

into this RJ-11 connector.

 Firmware Upgrade Switch: During normal operation this

switch should be in the NORMAL position. (See p. 41 for

firmware upgrading details.)

cl1008-1016.book Page 5 Thursday, January 20, 2011 5:24 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 72 73

Kommentare zu diesen Handbüchern

Keine Kommentare

ATEN CS-1008 Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Netzwerk-Switches ATEN CS-1008